Bay-Tek CONNECT 4 HOOPS Service Manual page 7

CONNECT 4 HOOPS GAME SETUP
The game will arrive on 4 pallets. Please inspect the pallets for shipping damage and report
immediately to the freight company if any damage found.
Unbox the pallets and remove parts attached, referring to the Shipping Checklist on the back of
manual to verify all parts are present.
Tools Needed:
1 step ladders (12-15 foot)
4 people
# 3 Phillips screwdriver bit
Important:
Portions of this game are heavy, bulky and large. Assembly requires 4 people to lift heavy
components, and ladders that are tall and strong enough to position components to the top of the
game.
Open the left (red) ticket door on the front console.
Pull out drawer slide and open the coin box.
Remove the hardware kit.
This hardware will be used to assemble the game.
Note: Game keys are located in small cardboard box on front
console.
Place the Upper Back Section down flat on floor in
approximate position of final game location.
Place the Lower Back Section down flat on floor and push
up against the top section.
The top edge of both sections should be even and flush.
# 2 Phillips screwdriver bit
# 1 Phillips screwdriver bit
# 2 Square head screwdriver bit 1" Crescent Wrench
7
2 of 9/16" Wrenches
7/16" Wrench