Bay-Tek CONNECT 4 HOOPS Service Manual page 17

CONNECT 4 HOOPS GAME SETUP
Locate both AAME10019 Side Metal Cages
These are interchangeable - it does not matter which side goes where.
Bring a cage to the side of the cabinet and pass it to a
person inside the cabinet to install. There are brackets
and plastic spacers attached to each of the 4 corners.
Install cage using black # 10 screws using a # 2 Square Head bit.
3 screws in each corner, total of 12 screws per side.
*** Repeat this process for the other side cage. ***
Locate 3 of WACA10000 Game Roof Boards
Place on top of game in the channel created by "L" brackets.
Ensure the T-nuts are facing upward.
Align holes in wood with holes in metal "L" bracket.
Install each board with 4 of the black ¼-20 X 1 Phillips head bolts using a
# 3 Phillips Head bit.
The bolt is screwed in from under the metal bracket, upward into the wood
and T-nut.
*** Repeat this process for the 2 other roof boards. ***
Snip the wire tie on the coiled cable in front left side of game. Uncoil
the cable along the top left side of game and plug into the
connector at the rear left of cabinet.
17
A5SCPH152
A5BOPH312