Bay-Tek CONNECT 4 HOOPS Service Manual page 18

CONNECT 4 HOOPS GAME SETUP
Locate the WACA10091 Clear Acrylic ball guard.
Remove the protective paper from both sides of the Acrylic plexi.
The flat edge bottom of the plexi will fit into the
groove between the white plastic and wood lip.
Slide acrylic plexi into place.
Hand thread 8 of 10-24 X 1 Phillips bolts with
3/16 X 3/4" lock washer and 3/16 X 3/4" fender
washer to get all started, then tighten all using a
#2 Phillips screwdriver bit.
A5BOPH210
To plug in game:
Remove power cord from small cardboard box. There are 2 options to access line filter socket:
Option #1:
If you have access to the back of the game, remove the 4
bolts using a 7/16" wrench.
Remove back panel.
Reach to the left to plug the power cord into the line filter.
Option #2:
If you do not have access to the back of the game, climb
inside the cabinet and remove the floor panel by removing
the 10 screws using a #2 Square bit.
Climb down under the cabinet to the right and plug the
power cord into the line filter.
Power on game:
Open the front middle door and turn on rocker switch on
the power strip.
A5WASI020
A5WAFE010
Note: The protective pa-
per should be removed by
the time the screws are insert-
18