Bay-Tek CONNECT 4 HOOPS Service Manual page 9

CONNECT 4 HOOPS GAME SETUP
Locate 2 of the A5ME10010 bottom side connector plates.
Install the plates on both sides of the cabinet with the black
¼-20 X 1 Phillips head bolts using a # 3 Phillips Head bit.
(10 per side)
Note: If the holes do not line up - adjust the leg leveler feet on the cabinet
using 1" Crescent Wrench.
Place the front Console Section in position close to the middle section to
install uprights and connect top marquee.
Locate the AAME10000-2 Back Left Pole
Line up the back left pole and test fit on the outside
of the cabinet. It will have the white plastic toward
the outside and rear of the cabinet.
Welded T-nuts to the outside of cabinet.
Once the correct pole is selected, feed the 2 cables
down into the hole in the left corner of the cabinet.
Slide pole down into the hole and line up the holes
in the cabinet with the pole.
Hand thread 2 of 3/8-16 X 1 1/2" bolt with 3/8"
washer to get both started, then tighten both using
a 9/16" wrench.
Feed the 2 cables from the pole down and connect the
ground cable and the non-colored connectors at the bottom of cabinet.
A5BOPH312
A5SCHH010
9
A5WAFL050