Bay-Tek CONNECT 4 HOOPS Service Manual page 8

CONNECT 4 HOOPS GAME SETUP
Locate the 2 of A5ME10012 middle back connector plates.
Install the plates on both sides of the cabinet
with 16 of the black ¼-20 X 1 Phillips head
bolts using a # 3 Phillips Head bit.
(8 per side)
Warning: Use 4 people to lift the top of game upward and
stand the assembled back sections upright onto the leg
leveler feet.
Game standing height is 137" , but ceiling height
should be 141" to accommodate this to tip upward.
Carefully slide the upright back of game into final game
position. We recommend to leave a 1-2 foot gap between
the game and the wall behind it if possible.
Place the Middle Section (Reference page 8) in position
close to the back section to connect cables before sliding into
final position.
On the left side - uncoil the USB cable - push this through the
middle cabinet section and through the front cabinet when the
time comes and plug into the motherboard.
Plug in the yellow connectors, and both pink connectors.
On the right side - connect the orange connectors.
A5BOPH312
8