Bay-Tek CONNECT 4 HOOPS Service Manual page 11

CONNECT 4 HOOPS GAME SETUP
Locate the AAME10000-3 Front Right Pole. This right pole will have the AC power cord
inside.
Feed the 3 cables down into the hole on the right corner of the cabinet.
Ensure to route the male side of power cable into the hole first to
ensure the correct end of pole is being used.
Slide pole down into the hole and line up the bolt holes in the
cabinet with the pole.
Hand thread 2 of 3/8-16 X 1 1/2" bolt with 3/8"
washer to get both started, then tighten both using
a 9/16" wrench.
Open the front right ticket door, slide out ticket tray a bit,
and connect the 3 cables to the cables near door hinge.
Clip cables into wire holder above ticket tray so they do not
interfere with ticket tray sliding in and out.
Excess cable can now be pulled up into pole and will end
up in the top marquee sign.
The front console with poles is separated from the rear 2
sections.
Close and lock both ticket doors and remove keys.
The front console with poles will be laid down on it's front to
install the top marquee.
Once the front marquee is attached, the front console will be
tilted back up in place and will be
the rear sections.
It is very important to have 4 people ready to hold in
position until it is secured!
The game will now look like this:
unstable until attached to
A5SCHH010
11
A5WAFL050