Bay-Tek CONNECT 4 HOOPS Service Manual page 10

CONNECT 4 HOOPS GAME SETUP
Locate the AAME10000-1 Back Right Pole
Feed the 2 cables down into the hole in the right corner of
the cabinet. Slide pole down into the hole and line up the
holes in the cabinet with the pole.
The white plastic must be toward the outside of the cabinet.
Hand thread 2 of 3/8-16 X 1 1/2" bolt with 3/8"
washer to get both started,
then tighten both using a
9/16" wrench.
Feed the 2 cables from the pole down
and connect the ground cable and the
non-colored connectors.
Locate the AAME10000-4 Front Left Pole This left pole will have the HDMI cable inside.
Feed the 4 cables down into the hole on the left corner
of the cabinet. Ensure to route the male side of HDMI
cable into the hole first to ensure the correct end of
pole is being used.
Slide pole down into the hole and line up the bolt holes
in the cabinet with the pole.
Hand thread 2 of 3/8-16 X 1 1/2" bolt with 3/8"
washer to get both started, then tighten both using
a 9/16" wrench.
Open the front left ticket door, slide out ticket tray a bit, and connect the 4
cables to the cables near door hinge.
Clip cables into wire holder above ticket tray so they do not interfere with
ticket tray sliding in and out.
Excess cable can now be pulled up into pole and will end up in the top
marquee sign.
A5SCHH010
10
A5WAFL050
A5SCHH010
A5WAFL050