Error Handling - Kemper KHS Mini System Control Installation And Operating Instructions Manual

8.1.4.9 Error handling

All the errors that occur in the system are sent to the KHS Mini System Control -MASTER 2.0- and are
signalled acoustically through a buzzer. It is possible to integrate an alarm relay (see Chapter 6.2.2.8).
In normal operation, the alarm relay is energized ("pulled") with voltage. If there is an error, the voltage
drops and an acoustic signal reports the error. During this it does not matter what kind of impact the
malfunction could have on the system. The control goes into alarm latching and has to be
acknowledged after the malfunction has been repaired.
Switch off / acknowledge buzzer
1 x OK Buzzer off
The control remains in alarm
latching
Error display
The errors of the MASTER / SLAVE
controls are displayed flashing in the
general plan with a lightning icon
Change into the detail view
2 x OK Selected control
Acknowledge error
After the malfunction has been
repaired, the malfunction can
be acknowledged in the detail
display
1 x OK Acknowledge error
Manual KHS Mini System Control
Ill. 8.46 Acknowledge the buzzer
Ill. 8.47 Error display
Ill. 8.48 Acknowledge the error
42