Table of Contents
Advertisement
3.
Safety
The descriptions and instructions in these
operating instructions concern the KHS Mini
System Control -MASTER 2.0- and KHS
Mini
System
Control
prerequisite for handling the controller is the
deployment
of
professionally
personnel as per DIN EN 50110-1.
3.1
Safety Instructions
Before commissioning, make sure the connections have been made properly and professionally and
that the system is properly protected. Comply with the pertinent regulations (EN, VDE, etc.) and the
regulations of the local energy utility.
3.2
Hazards if the safety instructions are not complied with
Non-compliance with the safety instructions can result in both hazards to people and hazards to the
environment and the system. Non-compliance with the safety instructions leads to the loss of rights to
any compensation claims. In some cases, non-compliance can, for example, result in the following
hazards:
Failure of important functions in the device
Hazards to people through electrical and mechanical effects
3.3
Unauthorized alteration and spare part fabrication
Alternations and modifications to the device are only permissible after agreement with the
manufacturer. Original spare parts and manufacturer authorised accessories serve the purpose of
safety. The use of any other parts may annul the liability for any resultant consequences.
Attention:
Use only original/approved spare parts
recognized.
3.4
Unauthorised modes of operation
The reliability of the supplied unit is only ensured when used as intended. Never exceed the limits
stated in this documentation under any circumstances.
Note:
If the operating instructions are not followed, the manufacturer of this controller
does not assume any responsibility. These operating instructions contain basic
instructions that must be complied with during set-up, commissioning and
maintenance.
specialists/operators must read these operating instructions before assembly and
commissioning. Comply not only with the general safety instructions listed in this
main point; also follow the specific safety instructions listed under the other main
points.
Manual KHS Mini System Control
-SLAVE-.
The
trained
Therefore,
the
plumber/mechanic
3
Warning notice:
During
assembly
maintenance, make sure that
the control is not switched on.
Only
skilled
professional
personnel are permitted to
operate
electrical
Danger of fatal electric shock.
otherwise no warranty claims will be
and
the
and
systems.
responsible
Advertisement
Table of Contents
Need help?
Do you have a question about the KHS Mini System Control and is the answer not in the manual?