Advertisement
Password Policy
(Permissions: User Administrator)
Settings by SNMPv1, v2
(Permissions: Network Administrator)
Password Entry Violation
(Permissions: Machine
Administrator)
Specify whether to limit the text and the number of
characters for the user password when using Basic
Authentication.
Specify a password using a combination of 2 or more
types of characters for [Level 1] and 3 or more types of
characters for [Level 2] selected from the types described
below.
Upper-case letters, lower-case letters, decimal
numbers, and symbols such as #
You can specify passwords that meet the conditions
specified in complexity and minimum character number.
Default
Complexity Setting: [Off]
Minimum Number of Characters:
[0] characters
Specify whether to prohibit setting change on the
machine by SNMPv1/v2 protocol. You can change the
machine configuration without Administrator Privileges
because authentication cannot be performed by
SNMPv1/v2 protocol, but if you specify [Prohibit], you can
prevent the change that is not intended by the
administrator.
Default: [Do not Prohibit]
Specify the standards that the system recognizes the
access as a password attack. If the number of
authentication requests exceeds the number specified by
the setting, the access is recorded in the Access Log and
the log data is sent to the machine administrator by e-
mail.
You can specify Maximum Allowed Number of Access up
to 100 and Measurement Time up to 10 seconds. If the
Maximum Allowed Number of Access is set to "0",
password attacks are not detected.
If you receive violation detection e-mails frequently,
check the content and review the setting values.
Default
Maximum Allowed Number of Access:
[30] time(s)
Measurement Time: [5] second(s)
Advertisement
