Advertisement
6. Enter the information for the LDAP Server.
Name: Enter a registration name. The name is to distinguish the server from another
LDAP server.
Server Name: Enter the host name or IPv4 address of the LDAP server.
Search Base: Select a root folder to start a search. E-mail addresses stored in this folder
are search targets when files are sent using the Scanner or Fax function.
Port Number: Enter the port number used for the communication with the LDAP server.
Use Secure Connection (SSL): When set to [On], the port number is changed to 636.
When set to [Off], security problems may occur.
Encrypting Network Communication
Authentication: Select the authentication method according to the authentication settings
of the LDAP server.
Kerberos Authentication: Authentication is performed on the KDC server. The
password is protected with encryption and is then sent to the KDC server.
When you select [Kerberos Authentication], specify the following:
User Name, Password: Enter the user name and password of the account that
requests Search to the LDAP server (administrator or representative). For the
search request with the authentication information of the user, do not enter.
You can browse the Address Book instead of entering the user name and
password directly.
Realm Name: Select the Realm Name. Register the Realm in advance.
Registering the Realm
Digest Authentication: Authentication is performed on the LDAP server. This method
is only available on a server supporting LDAP version 3.0. The password is protected
with encryption and is then sent to the LDAP server.
Cleartext Authentication: The password is sent to the LDAP server without
encryption.
Off: Select when server authentication is not required.
Japanese Character Code: Select the Japanese character code used on the LDAP server
(if applicable).
7. Press [Connection Test].
Advertisement
