Table of Contents
Advertisement
Scheduled Maintenance
1.3 Scheduled Maintenance
This section contains the maintenance and inspection
schedule that is to be performed.
References are made to the procedures in Section
5 that outline detailed step-by-step instructions for
checks and replacements.
1.3-1 Service Bulletins
Before performing any scheduled maintenance
inspection procedure, refer to the service bulletins
found on our website:
www.skyjack.com
related to the service and maintenance of this MEWP .
1.3-2 Maintenance and Inspection
Death or injury can result if the MEWP is not kept in
good working order. Inspection and maintenance
should be performed by competent personnel who
are trained and qualified on maintenance of this
MEWP .
WARNING
Failure to perform each procedure as presented
and scheduled may cause death, serious injury or
substantial damage.
NOTE
Preventive maintenance is the easiest and least
expensive type of maintenance.
Unless otherwise specified, perform each
▪
maintenance procedure with the MEWP in the
following configuration:
MEWP parked on a flat and level surface
▪
Disconnect the batteries by disconnecting the
▪
main power connectors.
Repair any damaged or malfunction
▪
components before operating MEWP .
Keep records on all inspections.
▪
SJ85 AJ
1.3-3 Maintenance Instructions
This manual consists of four schedules to be done for
maintenance on a MEWP . The inspection schedule
frequency is shown below:
Issue or Symptom
PDI/Frequent
for updates
Annual
Additional
▪
▪
▪
▪
▪
▪
Legend
Pass
Fail
Repaired
Not applicable
Section 1 – Scheduled Maintenance
B
Perform a PDI prior to each
delivery, or a Frequent
Inspection every 200 days
or 200 hours.
B + C
Perform Scheduled
Maintenance Inspections
every year.
*
Perform at time sensitive
maintenance intervals.
Make copies of the maintenance and inspection
checklist to be used for each inspection.
Check the schedule on the checklist for the type
of inspection to be performed.
Place a check in the appropriate box after each
inspection procedure is completed.
Use the maintenance and inspection checklist
and step-by-step procedures in Section 1 to
perform these inspections.
If any inspection receives a fail, tag and remove
the MEWP from service.
If any MEWP component(s) has been repaired,
an inspection must be performed again before
removing the tag. Place a check in the repair
column.
P
F
R
N/A
229044ADA
15
Advertisement
Table of Contents
