Grease Points; Grease The Turret Ring Gear; Grease The Turret Swing Drive - Skyjack SJ85 AJ Service Manual

Section 5 – Procedures

5.10 Grease Points

Maintaining proper lubrication is essential for the good performance and service life of the MEWP . If the bearing
and gear of the MEWP are improperly greased, it could result in component damage.

5.10-1 Grease the Turret Ring Gear

1. Open the control side cowling, and locate the turret ring gear grease fitting beside the hydraulic tank.
2. Pump grease into the fitting, and continue pumping until new lube appears continuously around the grease
seal lip of the ring gear.
3. Rotate the turret in increments of 10 to 13 cm (4 to 5 inches) at a time, and repeat step 2 until the entire
bearing has been greased.

5.10-2 Grease the Turret Swing Drive

1. Apply open gear lube to each tooth of the swing drive gear, located under the turret.
229044ADA
208
Grease Points
SJ85 AJ