Table of Contents
Advertisement
Platform
5.1-9 Remove and Replace the Platform
1. Lower the platform until it is resting on the
ground.
2. Before removing the platform from the machine,
the electrical harnesses routed across the
platform swivel joint must be disconnected.
3. Disconnect the two 24-pin control cables from
the bottom of the control box.
SJ85 AJ
4. Remove the auxiliary AC receptacle box (if
equipped). Remove the cable clamps.
M62018AA
5. Open the control box lid to disconnect the jib
and platform rotate harness. Remove the tie
wraps and make note of the wire labels and
locations for reinstallation.
6. To release each wire, insert a small flat
screwdriver into the slot beside it in the terminal
strip.
M62067AA
Section 5 – Procedures
M62191AA
M62321AA
229044ADA
153
Advertisement
Table of Contents
