Table of Contents
Advertisement
Turret
5.5-3 Check the Swing Drive Oil
1. Raise the riser and support it with a suitably
rated lifting device, or cylinder chocks on both
riser cylinder rods.
2. Slowly lower the riser until it is just above the
supportive device being used.
3. Remove the plug from the fill port
of the swing drive.
4. Check the oil level. The oil level should be
slightly below the port threads.
5. Add oil if needed. Refer to
and Features - Engines & Fluids
recommended oil types.
1
SJ85 AJ
on the back
1
2.13 Specifications
for
5.5-4 Change the Swing Drive Oil
NOTE
The oil change must be performed on a flat, level
surface.
1. Raise the riser and support it with a suitably
rated lifting device, or cylinder chocks on both
riser cylinder rods.
2. Slowly lower the riser until it is just above the
supportive device being used.
3. Remove the plug at the fill port
4. Place a suitable container under the drain
port
.
2
2
5. Remove the plug at the drain port.
6. Allow the oil to drain.
7. Reinstall the drain plug.
8. Refill the swing drive with approximately 1 L
(32 oz) of oil (refer to
Features - Engines & Fluids
oil types).
9. Reinstall the plug at the fill port.
Section 5 – Procedures
.
1
1
2.13 Specifications and
for recommended
229044ADA
163
Advertisement
Table of Contents
