Table of Contents
Advertisement
Aggressive, acidic or alkaline cleaning agents
can destroy the protective coating of adjacent
components, such as the brake disk.
After cleaning, apply the brakes shortly to dry
them. The heat generated during braking dries
brake disks and brake pads and protects them
against corrosion.
Chrome surfaces
Carefully clean Chrome surfaces, especially in
case of exposure to road salt, with plenty of
water and added auto shampoo as needed.
Rubber components
Environmental influences can cause surface
contamination of rubber parts and a loss of
gloss. Use only water and suitable cleaning
agents for cleaning.
Treat especially worn rubber parts with rubber
care products at regular intervals. When clean-
ing rubber seals, do not use any silicon-con-
taining vehicle care products in order to avoid
damage or noises.
Wiper blades
The wiper blades are cleaned by using the
washer system.
Avoid cleaning the wiper blades manually, as
this may reduce wiper performance.
Fine wood parts
Clean the fine wood veneer and fine wood
components solely with a moist rag. Then dry
with a soft cloth.
Kenaf
Only treat parts made of Kenaf fibers using
suitable care products.
Online Edition for Part no. 01405A7B930 - II/23
Vehicle Care
Plastic components
NOTICE
Solvent cleaners that contain alcohol or sol-
vents, such as lacquer thinners, cold cleaning
agents, fuel and such, can damage plastic
parts. There is a risk of damage to property.
Clean with a microfiber cloth. Dampen the
cloth lightly with water, if needed.
Do not soak the headliner.
Seat belts
Warning
Chemical solvent cleaners can destroy the
seat belt fabric. Missing protective effect of
the seat belts. There is a risk of injury or dan-
ger to life. Use only a mild soap solution for
cleaning the seat belts.
Dirty belt straps impede the reeling action and
thus have a negative impact on safety.
Use only a mild soap solution for cleaning the
installed belt straps.
Seat belts should only be allowed to retract if
they are dry.
Carpets and floor mats
Warning
Objects in the driver's footwell can limit the
pedal travel or block a depressed pedal.
There is a risk of accident. Stow objects in the
vehicle such that they are secured and can-
not enter into the driver's footwell. Use floor
mats that are suitable for the vehicle and
can be safely attached to the floor. Do not
use loose floor mats and do not layer several
floor mats. Make sure that there is sufficient
clearance for the pedals. Ensure that the floor
MOBILITY
371
OwnersManuals2.com
Advertisement
Table of Contents
