Table of Contents
Advertisement
The system is switched on once.
▷
Departure time with weekday: time and day
of the week of the scheduled departure can
be set.
The departure time is preselected in two steps:
▷
Set departure times.
▷
Activate departure times.
The climate control function will start approx-
imately 10 minutes before the set departure
time and continue for approximately 5 more
minutes after the departure time.
A minimum of 10 minutes should pass be-
tween setting/activating the departure time
and the planned departure time to allow a suf-
ficient period of time for the climate control.
For reasons of safety, the system can only be
switched on once. The system will be available
again as soon as the drive-ready state is acti-
vated and deactivated again.
Observe the information about the intended
use of the vehicle.
Additional information:
For Your Own Safety, refer to page 8.
Adjusting the departure time via iDrive
1.
"CAR"
2.
"Settings"
3.
"Climate control"
4.
"Preconditioning/ventilation"
5.
"Departure plan"
6.
Select the desired departure time.
7.
Set the departure time.
8.
Select day of the week, if needed.
Adjusting the departure time via BMW
display key
1.
Switch on the display of the BMW display
key.
2.
"Preconditioning setting"
3.
Tap on the icon.
Online Edition for Part no. 01405A7B930 - II/23
Climate control
4.
Select the desired departure time.
5.
Set the departure time.
6.
Select day of the week, if needed.
7.
"OK"
Activating the departure time via iDrive
1.
"CAR"
2.
"Settings"
3.
"Climate control"
4.
"Preconditioning/ventilation"
5.
"Departure plan"
6.
Activate the desired departure time.
Activating the departure time via BMW
display key
1.
Switch on the display of the BMW display
key.
2.
"Preconditioning setting"
3.
Tap on the icon.
4.
Activating the desired departure time:
Tap on the icon.
Display
In the instrument cluster:
The engine runs for the purpose
of operating the pre-condition-
ing. The vehicle is not ready to
drive.
The icon on the automatic climate
control signals an activated departure time.
The icon flashes while Remote Engine Start
is running.
Confirmation signals from the
vehicle
The activation of the system is confirmed by
flashing twice.
The parking lights are switched on as long as
the system is switched on.
CONTROLS
283
OwnersManuals2.com
Advertisement
Table of Contents
