Table of Contents
Advertisement
Warning light flashes: A lane boundary has
been crossed.
Additional information:
Steering Assistant, refer to page 237.
Steering and Lane Control Assistant:
hands not on steering wheel
Hands are not grasping the steering
wheel. The system is still active.
Grab the steering wheel with your
hands.
Additional information:
Steering Assistant, refer to page 237.
Dynamic Stability Control
Warning light flashes: Dynamic Stabil-
ity Control is regulating the drive and
brake power. The vehicle is stabilized.
Reduce the vehicle speed and adjust your driv-
ing style to the road conditions.
Warning light illuminates: Dynamic Stability
Control has failed or is being initialized. Driving
stability is restricted or has failed.
If the warning light illuminates continuously,
have the vehicle checked immediately by an
authorized service center or another qualified
service center or repair shop.
Additional information:
Dynamic Stability Control, refer to page 216.
The Dynamic Stability Control
deactivated or the Dynamic Traction
Control activated
The Dynamic Stability Control is deacti-
vated or the Dynamic Traction Control
is activated.
Additional information:
Online Edition for Part no. 01405A7B930 - II/23
Displays
▷
Dynamic Stability Control, refer to
page 216.
▷
Dynamic Traction Control, refer to
page 217.
Flat tire monitor
Warning light illuminates: Flat Tire
Monitor is indicating a flat tire or tire
pressure loss.
Reduce your speed and stop cautiously. Avoid
sudden braking and steering maneuvers.
Additional information:
Flat tire monitor, refer to page 336.
Tire pressure monitor
Warning light illuminates: Tire Pressure
Monitor is indicating a flat tire or tire
pressure loss. Follow the information in
the Check Control message.
Warning light flashes then illuminates continu-
ously: Flat tires or tire pressure losses cannot
be detected.
▷
Fault caused by systems or devices with
the same radio frequency: after leaving the
area of the interference, the system auto-
matically becomes active again.
▷
In the case of tires with special appro-
val: the tire pressure monitor was unable
to complete the reset. Reset the system
again.
▷
Wheel without wheel electronics installed:
Have it checked by an authorized service
center or another qualified service center or
repair shop as needed.
▷
Malfunction: have the vehicle checked by
an authorized service center or another
qualified service center or repair shop.
Additional information:
Tire pressure monitor, refer to page 328.
CONTROLS
163
OwnersManuals2.com
Advertisement
Table of Contents
