Table of Contents
Advertisement
Control elements on the interior
mirror
▷
Buttons, arrow 1.
▷
LED, arrow 2.
▷
The hand-held transmitter, arrow 3, is re-
quired for programming.
Programming
General information
The battery of the hand-held transmitter must
be fully charged at the time of programming
to ensure an optimal range of the integrated
universal remote control.
1.
Turn on standby state.
2.
Initial commissioning:
Press and hold the two outer buttons
on the interior mirror simultaneously for
approximately 10 seconds until the LED
flashes green rapidly. This erases all pro-
gramming of the buttons on the interior
mirror.
3.
Press the interior mirror button to be pro-
grammed. The LED on the interior mirror
will slowly begin flashing orange.
4.
Hold the hand-held transmitter for the sys-
tem to be used approx. 1 to 12 in/2.5 to
30 cm away from the buttons on the inte-
rior mirror. The required distance depends
on the hand-held transmitter.
5.
Press and hold the button of the desired
function on the hand-held transmitter.
Online Edition for Part no. 01405A7B930 - II/23
Interior equipment
Canada: if programming with the hand-held
transmitter was interrupted, hold down the
interior mirror button and repeatedly press
and release the hand-held transmitter but-
ton for 2 seconds.
6. ▷
The LED illuminates green: program-
ming completed.
Release the button.
▷
The LED flashes fast: programming is
not complete.
Press the button on the interior mirror
for 2 seconds and release. Perform this
procedure three times to complete the
programming procedure.
If the integrated universal remote con-
trol remains nonoperational, continue
with the special features for change
code wireless systems.
▷
LED does not flash green after 60 sec-
onds: programming not completed.
Repeat steps 3 to 6.
To program other functions on other buttons,
repeat steps 3 to 5.
Special feature of the rolling code
wireless system
If you are unable to operate the remote-con-
trolled system after repeated programming,
please check if the system to be controlled fea-
tures a rolling code radio system.
Refer to the operating instructions for the sys-
tem.
For systems with a rolling code radio system,
the integrated universal remote control and the
system also have to be synchronized.
Please read the operating instructions to find
out how to synchronize the system.
Synchronizing is easier with the aid of a sec-
ond person.
CONTROLS
285
OwnersManuals2.com
Advertisement
Table of Contents
