Table of Contents
Advertisement
3.
Unscrew the valve cap from the wheel and
screw the connecting piece of the hose
onto the valve.
4.
Insert the connector into the socket in the
vehicle interior.
5.
Read the tire pressure on the tire pressure
display of the compressor.
Do not continue driving unless a minimum
tire pressure of 1.3 bar/19 psi is displayed.
Contact an authorized service center or an-
other qualified service center or repair shop.
6.
Correct the tire pressure to 2.5 bar/36 psi.
▷
Increase tire pressure: with standby or
drive-ready state turned on, turn on the
compressor and let it run for a maxi-
mum of 10 minutes.
▷
Reduce tire pressure: press the pressure
reducing valve button on the compres-
sor.
Remove and stow the tire repair set
1.
Switch off the compressor.
2.
Pull the connector out of the socket in the
vehicle interior.
3.
Disconnect the hose from the compressor
and the valve on the wheel.
4.
Unscrew the valve cap.
5.
Stow the tire repair set in the cargo area.
Continuing the trip
Do not exceed the permissible maximum
speed of 50 mph/80 km/h.
Online Edition for Part no. 01405A7B930 - II/23
Wheels and tires
Do not exceed a maximum distance travelled
of 125 miles/200 km.
Re-initialize the flat tire monitor or reset the
Tire Pressure Monitor.
Replace the faulty tire and the sealant bottle of
the tire repair set promptly.
Additional information:
▷
Flat tire monitor, refer to page 336.
▷
Tire pressure monitor, refer to page 328.
System limits
If the tire cannot be made drivable, contact an
authorized service center or another qualified
service center or repair shop.
With the Tire Pressure Monitor: using sealant
can damage the wheel electronics. In this case,
have the electronics checked and replaced at
the next opportunity.
Snow chains
Safety information
Warning
Mounting snow chains on unsuitable tires
can cause the snow chains to come into con-
tact with vehicle parts. There may be a risk
of accidents or risk of damage to property.
Only mount snow chains on tires that are
designated by their manufacturer as suitable
for the use of snow chains.
Warning
Insufficiently tight snow chains may damage
tires and vehicle components. There may be
a risk of accidents or risk of damage to prop-
erty. Make sure that the snow chains are al-
ways sufficiently tight. Re-tighten as needed
according to the snow chain manufacturer's
instructions.
MOBILITY
327
OwnersManuals2.com
Advertisement
Table of Contents
