Table of Contents
Advertisement
DRIVING TIPS
This phenomenon is referred to as aquaplan-
ing. It is characterized by a partial or complete
loss of contact between the tires and the road
surface, ultimately undermining your ability to
steer and brake the vehicle.
Driving through water
General information
When driving through water, follow the follow-
ing:
▷
Deactivate Auto Start/Stop function.
▷
Drive through calm water only.
▷
Drive through water only up to a maximum
height of 9.8 inches/25 cm.
▷
Drive through water at a maximum of walk-
ing speed, up to 3 mph/5 km/h.
Safety information
NOTICE
When driving too quickly through deep water,
the water can penetrate the engine compart-
ment, the electrical system, or the transmis-
sion. There is a risk of damage to property.
When driving through water, do not exceed
the maximum indicated water level and the
maximum speed for driving through water.
Braking safely
General information
The vehicle is equipped with an Antilock Brak-
ing System as a standard feature.
Perform emergency braking in situations that
require such. To achieve the best possible
brake boosting, do not reduce the pressure on
the brake pedal during full braking.
Steering is still responsive. You can still avoid
any obstacles with a minimum of steering
movement.
304
Things to remember when driving
Online Edition for Part no. 01405A7B930 - II/23
The pulsation of the brake pedal and sounds
from the hydraulic circuits indicate that the An-
tilock Braking System is in its active mode.
In certain braking situations, the perforated
brake disks can emit function-related noises.
However, function-related noises have no ef-
fect on the performance and operational relia-
bility of the brake.
Objects in the travel path of the pedals
Warning
Objects in the driver's footwell can limit the
pedal travel or block a depressed pedal.
There is a risk of accident. Stow objects in the
vehicle such that they are secured and can-
not enter into the driver's footwell. Use floor
mats that are suitable for the vehicle and
can be safely attached to the floor. Do not
use loose floor mats and do not layer several
floor mats. Make sure that there is sufficient
clearance for the pedals. Ensure that the floor
mats are securely fastened again after they
were removed, for instance for cleaning.
Pedal feel when driving off
After turning on the drive-ready state from
the idle state, the pedal may feel unusual,
short pedal travel. After the brake pedal has
been fully released, the pedal will feel as usual
again.
Driving in wet conditions
In case of wet roads, exposure to road salt or
in heavy rain, gently depress the brake pedal
every few kilometers.
Ensure that this action does not endanger
other road users.
The heat generated during braking dries brake
disks and brake pads and protects them
against corrosion.
In this way the brake force will be available
when you need it.
OwnersManuals2.com
Advertisement
Table of Contents
