Table of Contents
Advertisement
CONTROLS
P is engaged automatically
Selector lever position P is engaged automati-
cally in situations such as the following:
▷
After the drive-ready state is switched off
and selector lever position R, D or M/S is
engaged.
▷
After the standby state has been turned off
when selector lever position N is engaged.
▷
The driver's seat belt is unbuckled, the driv-
er's door is opened, and the brake pedal is
not pressed while the vehicle is stationary
and the selector lever is set to D, M/S, or R.
Before exiting the vehicle, make sure that se-
lector lever position P is set. Otherwise, the
vehicle may begin to move. Also set parking
brake.
Additional information:
Parking brake, refer to page 142.
Engaging selector lever positions
General information
To prevent the vehicle from creeping after
you select a gear position or reverse, main-
tain pressure on the brake pedal until you are
ready to drive off.
Functional requirements
Only when the drive-ready state is switched on
and the brake pedal is depressed is it possible
to change from selector lever position P to an-
other selector lever position.
The selection lever position P cannot be
changed until all technical prerequisites are
met.
Engaging selector lever position D, N,
R
A selector lever lock prevents the following in-
correct operation:
150
Driving
Online Edition for Part no. 01405A7B930 - II/23
▷
Unintentional shifting into selector lever po-
sition R.
▷
Unintentional shifting from selector lever
position P into another selector lever posi-
tion.
1.
Fasten driver's seat belt.
2.
Press and hold the button to release the
selector lever lock.
3.
Push the selector lever in the desired direc-
tion, past a resistance point, if needed. The
selector lever automatically returns to the
center position when released.
Engaging selector lever position P
Press button P.
OwnersManuals2.com
Advertisement
Table of Contents
