Table of Contents
Advertisement
ELECTRICAL COMPONENTS: GASOLINE
VEHICLES
MALFUNCTION INDICATOR LIGHT
MALFUNCTION INDICATOR LIGHT REMOVAL
1.
Disconnect the battery and spark plug wire.
2.
Remove the instrument panel.
3.
Disconnect the malfunction indicator light (1) wires (Figure 19-42, Page 19-35). Do not allow wires to touch.
3003C
Figure 19-42 Malfunction Indicator Light
4.
Push the retaining tabs and remove the malfunction indicator light from the instrument panel.
MALFUNCTION INDICATOR LIGHT INSTALLATION
1.
Install the malfunction indicator light (1) in the instrument panel until plastic tabs engage instrument panel
(Figure 19-42, Page 19-35).
2.
Connect the malfunction indicator light (1) wires.
3.
Install the instrument panel. Make sure that the key switch terminals cannot touch the frame. Make sure that the
instrument panel is correctly seated and snapped in place.
4.
Connect the battery and spark plug wire.
FUEL GAUGE/HOUR METER
GENERAL INFORMATION
With the key switch in the OFF position, the fuel gauge field is blank; however, the hour meter field is always ON.
When the key switch is turned to ON, the fuel gauge field activates. The fuel gauge initially registers full before
indicating the actual fuel level.
The hour meter displays the number of hours of use in increments of 0.1 (one tenth) hour, but does not record
additional time unless the key switch is in the ON position and the engine is on. When recording, the hourglass icon
on the left blinks.
2019 Carryall 500 and 700 Maintenance and Service Manual
Malfunction Indicator Light
Page 19-35
19
Advertisement
Table of Contents
Troubleshooting
