Club Car Carryall 500 2019 Maintenance And Service Manual page 192

Gasoline vehicle with kohler ech440 engine electric vehicle with quiq charger
Table of Contents

Advertisement

12
Test Procedures
TEST PROCEDURE 4 – Fuses
See General Warnings on page 1-1.
WARNING
• Failure to use properly rated fuse can result in a fire hazard.
NOTE: These vehicles predominately use a combination of ATC-style and ATM-style blade fuses. A single AGC-style
glass fuse is used for the charger interlock circuit.
This is a voltage test. It can be performed relatively easily on ATC-style and ATM-style fuses. A voltage
test can be performed on the AGC-style glass fuse if insulation-piercing probes are used. Otherwise, the
AGC-style will have to be removed to visually inspect or check using a continuity test.
2976
Figure 12-5 Testing the Fuse
1.
If necessary, see Testing Basics on page 12-11.
2.
Access the fuses but do not remove them. Fuses are found at the following locations:
– On Controller Mounting Plate: 15-amp fuse to DC/DC converter, 2-amp fuse to connected car device
(Guardian/Visage V3 Circuit), and 15-amp fuse to electric powertrain
– Under Floorboard Near MCOR: 20-amp fuse from DC/DC converter to accessories
– Under Front Cowl: 15-amp fuse to cab, 10-amp fuse to brake lights, horn and turn signals, 7.5-amp fuse to
headlights and taillights, 10-amp fuse to 12-volt power strip and power point
– On Main Harness Near Controller Mounting Plate: 30-amp fuse for charger receptacle harness
– On Main Harness Forward of the 30-Amp Fuse: 1-amp fuse for charger interlock circuit
3.
2-Amp and 15-Amp ATC Fuses On Controller Mounting Plate and 30-Amp ATC Charger Receptacle Fuse:
With the batteries connected and the Run/Tow switch in the RUN position:
3.1.
Probe the two, small metal contacts on the top of the fuse (Figure 12-5, Page 12-16).
3.2.
Each contact should show BPV.
3.3.
If only one side shows BPV, replace fuse.
3.4.
If neither side of fuse shows BPV, do the following:
– Check BPV.
– Check condition and connection of large red wires at solenoid.
– Check sonic weld_8 in main wire harness.
Page 12-16
2019 Carryall 500 and 700 Maintenance and Service Manual
ELECTRICAL SYSTEM TROUBLESHOOTING:
IQ PLUS ELECTRIC VEHICLES

Advertisement

Table of Contents
loading

This manual is also suitable for:

Carryall 700 2019

Table of Contents