Club Car Carryall 500 2019 Maintenance And Service Manual page 304

18
Test Procedures
TEST PROCEDURE 8 – Maintenance/Operate Switch – Pedal-Start Vehicles
See General Warnings on page 1-1.
NOTE: This is a continuity test.
The Maintenance/Operate Switch is also known as the Neutral Lockout Switch.
1. If necessary, see Testing Basics.
2. Remove the wires from switch.
1
T1
Toggle Position
Wire Connections: T1 – Black/Pink Stripe, T2 – Black,
T3 – Black/Yellow Stripe
478
Figure 18-8 Maintenance/Operate Switch Test – for
Pedal-Start Vehicles
3. Set the switch to MAINTENANCE (1) (Figure 18-8):
3.1. Check for no continuity between terminals T1 and T2. If there is continuity, replace the switch.
3.2. Check for continuity between terminals T2 and T3. If there is no continuity, replace the switch.
4. Set the switch to OPERATE (2):
4.1. Check for no continuity between terminals T2 and T3. If there is continuity, replace the switch.
4.2. Check for continuity between terminals T1 and T2. If there is no continuity, replace the switch.
5. If the switch works as stated and the MAINTENANCE/OPERATE modes still do not work:
5.1. Check the limit switches.
5.2. Check continuity of the wires involved.
Page 18-18 2019 Carryall 500 and 700 Maintenance and Service Manual
2
T2 T3
1. MAINTENANCE closes
T2 to T3
2. OPERATE closes T1 to T2
TROUBLESHOOTING AND ELECTRICAL
SYSTEM: GASOLINE VEHICLES