Club Car Carryall 500 2019 Maintenance And Service Manual page 74

5
Pedal Group Adjustment – Electric Vehicles
1
2
0.060 inch
(1.5 mm)
A. Bottom View
B. Cutaway Side View
2643
4.3. With the park brake unlocked, measure and note the distance from the top of the accelerator pedal to the
floorboard, then lock the park brake (Figure 5-23, Page 5-18).
4.4. With the park brake locked, make sure at least 75% of ratchet tooth length engages the pawl (Figure 5-24,
Page 5-18). Tooth engagement should be between the two lines marked on the pawl.
Figure 5-23 Accelerator Pedal Height Measurement
4.5. With park brake still locked, measure the distance from the top of accelerator pedal to floorboard. If the
measurement has changed, ratchet tooth engagement is too deep and must be adjusted.
4.6. If ratchet/pawl engagement must be adjusted, disconnect the ball joint at the top of the brake rod and rotate
the ball joint sleeve clockwise to increase engagement or counterclockwise to decrease engagement.
Reconnect ball joint (Figure 5-25, Page 5-19).
4.7. Check for proper brake operation prior to driving the vehicle.
5. Adjust accelerator pedal height.
5.1. Loosen the nut and bolt (Figure 5-26, Page 5-19) securing the accelerator pedal to the pivot plate. Clamp
the accelerator pedal adjustment tool to the accelerator pedal, with the end marked accelerator pedal height
Page 5-18 2019 Carryall 500 and 700 Maintenance and Service Manual
A
Figure 5-22 Park Brake Ratchet/Pawl Gap Adjustment
ACCELERATOR AND BRAKE PEDAL GROUP
1
1. Locked Position
2. Ratchet (B) Tooth Length
3. Make sure pawl (A) engages at least 75% of ratchet tooth length (B).
Figure 5-24 Ratchet/Pawl Tooth Engagement
3
4
B
2
A
3
B