Amp Hours; Access Codes; Vehicle Id - Club Car Carryall 500 2019 Maintenance And Service Manual

CONTROLLER DIAGNOSTIC TOOL (CDT)
Charger Control
Beep Option
The Beep Option controls use of the reverse buzzer to sound a confirmation that charging has started: 0 = OFF, 1
= 1 beep, 2 = 3 beeps. From the factory, the Beep Option will be set to 2.

AMP HOURS

Reset Trip Amp Hours
The reset trip amp hours menu item allows the user to reset counter to zero (0). To reset, set to ON and then
immediately back to OFF. To review or validate, proceed to Amp Hours Display on page 11-15 under the Monitor Menu.

ACCESS CODES

Code A, Code B, and Code C
NOTE: Smartkey: Mode 2 and Code A, Code B, and Code C are available as part of the Smartkey option. The
Smartkey feature is available as a factory option, or as a field kit (102962602 Kit, Field, Smartkey) and can
be ordered from Service Parts.
The code entries are used to activate Mode 2 (M2) functions in the Parameters Menu. Each vehicle has a unique
code for placing the vehicle in this mode.
Once activated, Mode 2 settings can be programmed using the same procedures as Mode 1 settings. This allows
the vehicle to be customized to perform according to which mode it is operated in. For more information on this
feature, contact your local Club Car distributor or dealer.
To activate Mode 2:
1. Enter Code A, Code B, and Code C.
2. Turn the Run/Tow switch to Tow.
3. Wait 30 seconds.
4. Turn the Run/Tow switch to Run.
5. M2 options will now appear in the Parameters Menu.

VEHICLE ID

S/N ASCII Letter 1
S/N ASCII Letter 2
The two-letter serial number prefix is coded as two separate ASCII characters per the following table. For example,
serial number JE1401-000001 would have 74 for S/N ASCII Letter 1 and 69 for S/N ASCII Letter 2.
_
ASCII NUMBER ASCII CHARACTER
65
66
67
68
TABLE CONTINUED ON NEXT PAGE
ASCII NUMBER
A
B
C
D
2019 Carryall 500 and 700 Maintenance and Service Manual
ASCII CHARACTER
78 N
79 O
80 P
81 Q
11
Parameters
Page 11-9