Table of Contents
Advertisement
ELECTRICAL COMPONENTS: GASOLINE
VEHICLES
VOLTAGE REGULATOR
VOLTAGE REGULATOR REMOVAL
1.
Disconnect the battery and spark plug wire.
2.
Remove the electrical component box cover.
3.
Disconnect the voltage regulator red wire (1) at the large post on the solenoid (Figure 19-25).
2973B
Figure 19-25 Voltage Regulator
4.
Disconnect the yellow wire (2) at the bullet connector.
5.
Disconnect the black wire (3) from the (NO) terminal of the kill limit switch and at the battery frame ground.
6.
Remove the screw (4).
7.
Remove the voltage regulator (5).
VOLTAGE REGULATOR INSTALLATION
1.
Position the voltage regulator (5) in the electrical component box (Figure 19-25).
2.
Install the screw (4). Tighten the screw to 23 in·lb (2.6 N·m).
3.
Connect the voltage regulator red wire (1) at the large post on the solenoid.
4.
Connect the yellow wire (2) at the bullet connector.
5.
Connect the black wire (3) at the battery frame ground.
6.
Install the electrical component box cover. Be sure to firmly press down all corners.
7.
Install the box cover screw and tighten to 18 in·lb (2 N·m).
8.
Connect the battery and spark plug wire.
9.
Set the Forward/Neutral/Reverse control (FNR) to N.
10.
Set the Maintenance/Operate switch to MAINTENANCE.
11.
Start the engine.
12.
Make sure that the voltage regulator operates correctly. See the test procedure for voltage regulator.
2019 Carryall 500 and 700 Maintenance and Service Manual
19
Voltage Regulator
Page 19-19
Advertisement
Table of Contents
Troubleshooting
