Table of Contents
Advertisement
FUEL SYSTEM: GASOLINE VEHICLES
3.
Loosen adjustment screw jam nut (4) and back off throttle stop screw (5) several turns (Figure 21-8, Page 21-7).
A = 0.055 in. ± 0.039 (1.4 mm ± 1)
3111B
Figure 21-8 Throttle Stop Screw Gap
4.
Rotate governor arm counterclockwise until it stops and hold in this position.
5.
Adjust governor cable jam nuts until throttle lever is at "wide open throttle" (WOT) and tighten the governor cable
jam nuts to 36 in·lb (4.0 N·m).
6.
Release governor arm to return to "idle" position.
7.
Adjust gap (A) between governor arm and throttle stop screw to 0.055 in. (±0.039) (1.4 mm (±1)) as shown
(Figure 21-8, Page 21-7). Tighten stop screw jam nut to 36 in·lb (4.0 N·m).
8.
Check engine RPM adjustment. See Engine RPM Adjustment.
ACCELERATOR CABLE
Accelerator Cable Removal
1.
Disable the vehicle.
2.
Disconnect the battery and spark plug wire.
2019 Carryall 500 and 700 Maintenance and Service Manual
Engine Control Linkages
Page 21-7
21
Advertisement
Table of Contents
Troubleshooting
