Table of Contents
Advertisement
TROUBLESHOOTING AND ELECTRICAL
SYSTEM: GASOLINE VEHICLES
4.
5-amp ATM Fuse Only: With the key switch in the ON position:
4.1.
Probe the two, small metal contacts on the top of the fuse (Figure 18-2, Page 18-10).
4.2.
Each contact should show battery voltage.
4.3.
If only one side shows battery voltage, replace fuse.
4.4.
If neither side of a fuse shows battery voltage, inspect the following locations:
– 12-pin dash wire harness connector, key switch and sonic weld 3.
5.
2-amp ABC Glass Fuse Only: With the key switch in the ON position:
5.1.
Probe the wire on each side of the fuse with insulation-piercing probes.
5.2.
Each probe should show battery voltage.
5.3.
If only one side shows battery voltage, replace fuse.
5.4.
If neither side of a fuse shows battery voltage, inspect the following locations:
– 5-amp ATM fuse, 12-pin dash wire harness connector, key switch and sonic weld 3.
2019 Carryall 500 and 700 Maintenance and Service Manual
18
Test Procedures
Page 18-11
Advertisement
Table of Contents
Troubleshooting
