Rigol DHO900 User Manual page 33

Press
features including digital voltmeter (DVM), counter, power analysis, waveform
recording, and pass/fail.
4. Measure Key
Press
in the menu. For details, refer to
5. Cursor Key
Press
side "Result" bar. Three cursor modes are available: Manual, Track, and XY; wherein,
the XY mode is available only when the XY function is enabled.
6. Common Tools Keys
-
The oscilloscope is automatically configured to best display the input signals by
adjusting the vertical scale, horizontal timebase, and trigger mode. To set up
the key, please refer to
-
"RUN" or "STOP". In "RUN" state, this key is illuminated in green; in "STOP"
state, this key is illuminated in red.
-
trigger mode to "Single".
-
oscilloscope's default settings. You can also press the key and a dialog box is
displayed. Click or tap OK in the dialog to restore the oscilloscope's default
settings.
-
the oscilloscope is in "RUN" mode, it continues to display new waveforms.
7. Touch Lock Key
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
to access the Analyse menu. In this menu, you can access analysis
to access the Measure menu. You can select the waveform parameters
Select the Measurement Item
to enable cursor measurements. The results are displayed in the right-
is the auto scale key. Press this key to enable the auto scale function.
Auto Config
is the RUN/STOP key. Press the key to set the oscilloscope's run state to
is the key for a single acquisition. Press this key to set the oscilloscope's
is the default setup key. Press this key twice to directly restore the
is the clear key. Press this key to clear all waveform on the display. If
.
Quick Start
.
DHO800 User Guide
19