Rigol DHO900 User Manual page 155

-
-
You can enable cursor measurements in the following ways.
• Click or tap the function navigation icon
measurements.
• Click or tap the Cursors button on the toolbar to enable cursor measurements.
•
Press the front-panel
The measurement results are displayed in the "Result" bar at the right side of the
screen.
• AX: indicates the X value at Cursor A.
• AY: indicates the Y value at Cursor A.
•
BX: indicates the X value at Cursor B.
•
BY: indicates the Y value at Cursor B.
• ∆X: indicates the horizontal spacing between Cursor A and Cursor B.
• ∆Y: indicates the vertical spacing between Cursor A and Cursor B.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Cursor A is a horizontal solid line (
the screen), and Cursor B is a horizontal dotted line (
right section of the screen).
In XY cursor mode, Y cursor is used to measure the waveform amplitude of
Source Y.
key to enable cursor measurements.
Measurements
is displayed at the right section of
is displayed at the
> Cursors to enable cursor
DHO800 User Guide
141