Triggering the Oscilloscope
Trigger Type
Click or tap the drop-down button of Type to select "I2C".
After a trigger type is selected, the current trigger setting information (including the
trigger type, source, and level) is displayed in the trigger information label at the top
of the screen, as shown in the figure below. The information will change based on the
trigger settings.
Source Selection
Click or tap the drop-down buttons of SCL and SDA to select CH1-CH4 to specify the
sources of SCL and SDA respectively. For details, refer to descriptions in
DHO800 User Guide
98
Figure 8.26 Sequence Diagram of I2C Protocol
Figure 8.27 I2C Trigger Setting Menu
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Trigger