To Adjust The Vertical Offset - Rigol DHO900 User Manual

lower if the next scale is used, fine adjustment can be used to improve the
amplitude of waveform display to view signal details.
• Coarse adjustment: Use the icons at the right side of Scale or rotate the knob to
adjust the vertical scale in a 1-2-5 step sequence, i.e. 500 μV/div, 1 mV/div, 2
mV/div, 5 mV/div, 10 mV/div...10 V/div.
5.3

To Adjust the Vertical Offset

Vertical offset indicates the offset of the signal ground level position of the waveform
from the vertical center of the display. Its unit is consistent with the currently selected
amplitude unit (refer to
moves the corresponding channel's waveform up and down. The vertical offset
information (as shown in the following figure) in the channel status label at the
bottom of the screen will change accordingly.
Vertical
Offset
The adjustable range of the vertical offset is related to the current probe ratio and
vertical scale.
When CH1 is turned on and activated, you can adjust the vertical offset in the
following ways.
• Rotate the Vertical
adjust the vertical offset within the adjustable range. Rotate this knob clockwise
to increase the vertical offset, and rotate it counterclockwise to reduce the
vertical offset. Pressing down the knob can quickly reset the vertical offset (set
the vertical offset to 0).
• Enable the touch screen function, and then adjust the vertical offset with the
drag gesture. For details, refer to
• In the Vertical menu, click or tap the Up/Down arrow icon at the right side of the
input field of Offset to increase or decrease the offset value or use the
corresponding multipurpose knob to set the value. You can also click or tap the
input field to input a specific value with the pop-up numeric keypad.
Input Field
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
To Specify the Amplitude Unit
POSITION knob at the right section of the front panel to
Drag
.
Decrease Increase
Vertical System
). Adjusting the vertical offset
DHO800 User Guide
39