Setup/Hold Trigger; Figure 8.20 Setup/Hold Trigger - Rigol DHO900 User Manual

Triggering the Oscilloscope
Level Selection and Setting
After the trigger condition setting is completed, you need to adjust the trigger level
to correctly trigger the signal and obtain a stable waveform.
Click or tap the Level A/Level B input field to set the level A/level B with the pop-up
numeric keypad. You can also use the corresponding multipurpose knob to adjust
level A/level B or use the trigger level knob to adjust the level (the focus of the trigger
level knob is the last modified level). For details, refer to descriptions in
The current trigger level is displayed in the trigger information label at the top of the
screen.
8.7.11

Setup/Hold Trigger

In setup&hold trigger, you need to set the clock source and data source. The setup
time starts when the data signal passes the trigger level and ends at the coming of
the specified clock edge; the hold time starts at the coming of the specified clock
edge and ends when the data signal crosses the trigger level again, as shown in the
figure below. The oscilloscope triggers when the setup time or hold time is smaller
than the preset time.
Data Source
Clock Source
Trigger Type
Click or tap the drop-down button of Type to select "Setup/Hold".
DHO800 User Guide
90
T2
T1
Edge

Figure 8.20 Setup/Hold Trigger

Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Trigger Level
.
T1 is the setup time
T2 is the hold time
The data type is H