It is possible to reset the Wi-Fi settings and other settings in the Set-up menu.
■
The default settings are:
AP Mode:
WIFI Mode:
DataViewSync™:
Remote Password
Protection:
SELECT Button:
Recording:
The device will ask for confirmation before performing the reset. Press
■
the
button to confirm or any other button to cancel.
3.3 REMOTE USER INTERFACE
The remote user interface runs on a PC, tablet or smartphone. It allows you to
view device information.
Enable Wi-Fi on the PEL. The remote user interface can work with an access
■
point Wi-Fi
On a PC, connect as indicated in § 3.2.2.
■
On a tablet or smartphone, share a Wi-Fi connection.
■
■
In an Internet browser, enter http://device_IP_address.
For a Wi-Fi access point
■
For a Wi-Fi router
■
menu (see § 3.4).
The following screen will be displayed:
NOTE: Refreshing the display is not automatic. You need to do this
regularly.
28
- SSID = PEL52-[serial_number]
- Authentication = Open
- No SSID
- No Password
- Protocol = UDP
- Port = 3041
- Enabled
NOTE the DataViewSync™ password is not reset
- No password protection
- Unlocked
- Reset during recordings in progress is not possible
(set-up is locked).
link or a router Wi-Fi
connection, enter
connection, this address is indicated in the information
Power & Energy Logger Model PEL 52 - User Manual
link but not a DataViewSync™ link.
http://192.168.2.1
Figure 19