Table of Contents
Advertisement
The PEL must be configured before any recording. Follow the below steps to
configure the PEL:
Establish a Wi-Fi connection with the PC (to use the PEL Control Panel, see § 5).
■
Select the connection according to the type of distribution network.
■
Connect the current sensor(s).
■
Define the nominal primary current according to the current sensor used.
■
■
Select the aggregation period.
To configure the device, you can use the Configuration mode (see § 3.2)
or the PEL Control Panel.
NOTE: To avoid accidental changes, the PEL cannot be configured
while recording or if a recording is pending.
3.1 TURNING THE INSTRUMENT ON AND OFF
3.1.1 Turning On
Connect the PEL to Network between the V1 and N, and it will turn on
■
automatically. Otherwise, press and hold the ON/OFF button until the device
turns on.
The battery will charge automatically when the PEL is connected to a voltage
source between the V1 and N terminals. Battery life is approximately one hour
when fully charged. This allows the device to continue operating during brief
power cuts.
3.1.2 Auto Off
By default, the device operates in continuous mode, which is indicated by
the
symbol.
When the device is running on battery power, you can choose to have it turn
off automatically after a period with no keyboard activity and no recording in
progress to save battery life. This time will be defined in the PEL Control Panel
(see § 5).
3.1.3 Turning Off
You cannot turn the PEL off while it is connected to a power source or while a
recording is in progress or pending. This is a precaution intended to prevent a
recording from being unintentionally stopped by the user.
To turn the PEL off:
Disconnect the PEL.
■
Press and hold the ON/OFF button until the device turns off.
■
20
3. SETUP
Power & Energy Logger Model PEL 52 - User Manual
Advertisement
Table of Contents
