Mounting; Button Functions - AEMC PEL 52 User Manual

Power & energy logger

Hide thumbs Also See for PEL 52:

Table of Contents

2.6 MOUNTING

The PEL must be placed in a well-ventilated room where the temperature must

not exceed the values specified in § 6.5.

The PEL can be mounted on a flat, ferromagnetic surface using the magnets

incorporated in the PEL's housing.

NOTE: The strong magnets can damage hard drives or medical devices.

Button

Description

ON / OFF Button

■

Select Button

■

Navigation Buttons

►◄▲▼

■

Enter Button

■

If any button is pressed, the backlight will turn on for 3 minutes.

A long press will turn the device ON or OFF.

The device cannot be turned off while a recording is pending or in

progress.

When pressed, this button allows the user to start or stop a recording

and allows Wi-Fi mode to be chosen.

These buttons are used to configure the device and browse displayed

data.

In configuration mode, cycles through the available setting options and

determines the applied setting.

In measurement and power display modes, displays phase angles.

In select mode, starts or stops a recording after the Select button is

pressed. It also allows the type of Wi-Fi to be chosen.

Power & Energy Logger Model PEL 52 - User Manual

Table 1

Table of Contents