Figure 72: Tightening The Thumb Screws On The At-Sbx81Cfc960 Card - Allied Telesis SwitchBladex8112 Installation Manual

Section II: Installing the Chassis
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Figure 72. Tightening the Thumb Screws on the AT-SBx81CFC960 Card
10. Tighten the screws with a # 2 Phillips-head screwdriver to secure the
controller card to the chassis.
Allied Telesis recommends tightening the screws to 5 inch-lbs.
11. if the chassis is to have two AT-SBx81CFC960 Controller Fabric
Cards, repeat this procedure to install the second card.
12. After installing the controller cards, do one of the following:
 If you purchased AT-SBx81XLEM Ethernet Line Cards with
expansion modules, go to "Installing Expansion Modules in AT-
SBx81XLEM Ethernet Line Cards" on page 142.
 Otherwise, go to "Installing the Ethernet Line Cards" on page 150.
141