Figure 132: Removing The Terminal Screws - Allied Telesis SwitchBladex8112 Installation Manual

SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Figure 132. Removing the Terminal Screws
6. With a #3 Phillips-head screwdriver, connect the positive (+) power
lead wire to the positive terminal on the power supply, with one of the
terminal screws removed in the previous step. The positive terminal is
on the left. You may attach the terminals with the wires either above or
below the terminal block. Figure 133 on page 204 shows the positive
wire above the terminal block.
Allied Telesis recommends tightening the screw to 30 to 40 inch-lbs.
Section II: Installing the Chassis 203