Table 31. Descriptions Of The Stack Renumber Command Messages - Allied Telesis SwitchBladex8112 Installation Manual

Section III: Building a Stack with VCStack Plus
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide

Table 31. Descriptions of the STACK RENUMBER Command Messages

Message
Warning: Stacking is currently
disabled.
Warning: The new ID will not
become effective until the stack-
member reboots.
Warning: The boot configuration
may now be invalid.
5. After changing the ID number, enter the EXIT command to return to
the Privileged Exec mode:
awplus(config)# exit
awplus#
6. Enter the SHOW STACK command again to confirm your change.
An example of the window is shown in Figure 194 on page 318.
Description
This message reminds you that
even though you activated the
stacking feature with the STACK
ENABLE command in an earlier
procedure, the feature is disabled
because the chassis has not been
reset. You will reboot the switch
later in these instructions.
This message informs you that the
switch needs to be reset before it
begins to use its new ID number.
You will reboot the switch later in
these instructions.
This message informs you that if
you have already configured
parameter settings on the switch,
some of the settings may be lost
when you reset the unit. The ID
number is used in the commands
in the configuration file to identify
the individual switch ports. When
the ID number is changed,
commands in the configuration file
that use the old ID number are no
longer valid.
317