Figure 142: Connecting The Negative (-) Power Wire With A Right Angle Terminal - Allied Telesis SwitchBladex8112 Installation Manual

Table of Contents

Chapter 10: Powering On the Chassis

Figure 142. Connecting the Negative (-) Power Wire with a Right Angle

Check to see if there are any exposed copper strands coming from

the installed wires. When this installation is done correctly there

should be no exposed copper wire strands extending from the

terminal block. Any exposed wiring can conduct harmful levels of

electricity to persons touching the wires.  E12

8. With a #2 Phillips-head screwdriver, tighten the handle locking screw

to secure the power supply to the chassis. See Figure 143 on page

Section II: Installing the Chassis

Troubleshooting