Table of Contents
Advertisement
Chapter 7: Installing the AT-SBx81CFC960 Control Card and Ethernet Line Cards
154
9. Tighten the two screws with a # 2 Phillips-head screwdriver to secure
the line card to the chassis.
Allied Telesis recommends tightening the screws to 5 inch-lbs.
10. Repeat this procedure to install the remaining Ethernet line cards.
11. After installing the line cards. go to "Installing Blank Slot Covers" on
page 155.
Section II: Installing the Chassis
Advertisement
Table of Contents
Troubleshooting
