Allied Telesis SwitchBladex8112 Installation Manual page 283

Section II: Installing the Chassis
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Card in the chassis has a feature license, you must order a new
license from Allied Telesis for the AT-SBx81CFC960 Card and
install it after installing the new controller card.
 The command formats are presented in abbreviated versions to
simplify the procedure. To learn the complete formats of the
commands, refer to the Software Reference for SwitchBlade x8100
Series Switches.
 The procedure requires a flash drive to temporarily store the
configuration file from the old controller card prior to transferring it
to the new card. If you prefer to store the file on a different network
device, such as a TFTP server, refer to the description of the
COPY command in the Software Reference for SwitchBlade x8100
Series Switches for directions.
 This procedure assumes that the configuration file for the chassis
is stored in the root directory of flash memory on the AT-
SBx81CFC400 Controller Fabric Card. If the file is stored in a
subdirectory or on another network device, refer to the Software
Reference for SwitchBlade x8100 Series Switches for instructions.
 The procedure stores the configuration file in the root directory of
flash memory of the AT-SBx81CFC960 Controller Fabric Card. If
you prefer to store the file in a subdirectory of flash memory or on a
different network device, refer to the Software Reference for
SwitchBlade x8100 Series Switches for instructions.
283