Powering On At-Sbxpwrpoe1 Power Supplies; Figure 115: Connecting The Ac Power Cord For The At-Sbxpwrpoe1 Power Supply - Allied Telesis SwitchBladex8112 Installation Manual

Powering On AT-SBxPWRPOE1 Power Supplies

Section II: Installing the Chassis
SwitchBlade x8112 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
If you have not already installed the AT-SBxPWRPOE1 Power Supplies,
refer to "Installing AT-SBxPWRPOE1 PoE Power Supplies" on page 121
for installation instructions. To power on the power supplies, perform the
following procedure:
1. Identify AC sockets A and B in the recessed panel on the back panel of
the chassis, shown in Figure 112 on page 186. The sockets are for the
AT-SBxPWRPOE1 Power Supplies in slots A and B on the front panel
of the chassis.
2. Plug the AC power cord that comes with the power supply into one of
the plugs, as shown in Figure 115.
The plug should have a power supply in the corresponding slot in the
front panel. If the chassis has two AT-SBxPWRPOE1 Power Supplies,
you may power on either supply first.
Figure 115. Connecting the AC Power Cord for the AT-SBxPWRPOE1
Power Supply
189