Installing The Ethernet Line Cards; Figure 84: Slots 1 To 4 And 7 To 12 For The Ethernet Line Cards - Allied Telesis SwitchBladex8112 Installation Manual

Chapter 7: Installing the AT-SBx81CFC960 Control Card and Ethernet Line Cards

Installing the Ethernet Line Cards

150
This section contains the installation procedure for the Ethernet line cards.
The illustrations show the AT-SBx81GP24 Line Card, but the procedure is
the same for all the cards.
Note
Please review "Guidelines to Handling the Controller and Line
Cards" on page 134 before performing this procedure.
This procedure requires the following tools:
 #2 Phillips-head screwdriver (not provided)
 #2 Phillips-head, 5 inch-lbs torque screwdriver (optional — not
provided)
To install the Ethernet line cards, perform the following procedure:
1. Choose a slot in the chassis for the Ethernet line card. The Ethernet
line cards may be installed in slots 1 to 4 and 7 to 12. The slots are
shown in Figure 84.
Slot 1
Slot 3
Slot 7
Slot 9
Slot 11
Figure 84. Slots 1 to 4 and 7 to 12 for the Ethernet Line Cards
Note
The AT-SBx81XS16 and AT-SBx81XLEM Line Cards are supported
in slots 1 to 4, 8, and 10 in the AT-SBx8112 Chassis. They are not
supported in slots 7, 9, 11, and 12.
2. If the selected slot for the line card is covered with a blank slot cover,
use a #2 Phillips-head screwdriver to loosen the two captive screws on
the cover and remove it from the chassis. Refer to Figure 85 on page
151.
Slot 2
Slot 4
Slot 8
Slot 10
Slot 12
Section II: Installing the Chassis