Temperature Readout Selection; Ventilation System; Figure 5- 18 Temperature Readout Selection Screens; Figure 5- 19 Ventilation System Setup - Webasto SVS100 Installation, Operation And Maintenance Manual

5.10.8 Temperature Readout Selection

Allows the user to set the battery temperature display format to either degrees Fahrenheit or Celsius.
From the "Temperature Readout Selection" screen, press <enter> to display the current format. Press <enter>
again to enable editing. Use the <up> and <down> arrows to select the desired format for the temperature display
and press <enter> to save your configuration. Press <clear> to exit.
CLEAR

Figure 5- 18 Temperature Readout Selection Screens

5.10.9 Ventilation System

NOTE: This section is only applicable if a ventilation system has been installed and
connected to the charger.
The Ventilation System menus allow the user to set the ventilation system control parameters.
From this menu, the charger may be configured to turn the ventilation system off, to turn it on
only during Equalization, or to turn it on any time the vehicle is being charged.
From the "Ventilation System" screen Press <enter> and then Press <enter> again and the
status (ON or OFF) will flash. Press <up> or <down> to toggle between ON and OFF. Press
<enter> again to accept your selection. Press <clear> to exit.
CLEAR
23435-W-03-01
SVS100 Installation, Operation and Maintenance Manual
CLEAR
Temperature Readout
Selection
ENTER
CLEAR
Display Temp in:
Fahrenheit
Display Temp in:
Celsius
Ventilation System
Configuration
ENTER
CLEAR
Ventilation System
OFF
ENTER
Ventilation System
ON When Charging
Ventilation System
ON When EQing

Figure 5- 19 Ventilation System Setup

40
Charger Configuration
Charger Configuration
CLEAR
Verify Ventilation
ENTER
Connection
CLEAR
Verify Ventilation
ENTER
Connection
CLEAR
Webasto Charging Systems, Inc.