Ventilation System; Figure 5- 19 Temperature Readout Selection Screens; Figure 5- 20 Ventilation System Setup - Webasto SVS300 Installation, Operation And Maintenance Manual

SVS-200

5.10.9 Ventilation System

NOTE: This section is only applicable if a ventilation system has been installed and
connected to the charger.
The Ventilation System menus allow the user to set the ventilation system control parameters.
From this menu, the charger may be configured to turn the ventilation system off, to turn it on only
during Equalization, or to turn it on any time the vehicle is being charged.
From the "Ventilation System" screen Press <enter> and then Press <enter> again and the status
(ON or OFF) will flash. Press <up> or <down> to toggle between ON and OFF. Press <enter>
again to accept your selection. Press <clear> to exit.
CLEAR
20153-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
Temperature Readout
Selection
CLEAR
Display Temp in:
Fahrenheit
CLEAR
Display Temp in:
Celsius

Figure 5- 19 Temperature Readout Selection Screens

Ventilation System
Configuration
ENTER
CLEAR
Ventilation System
OFF
ENTER
Ventilation System
ON When Charging
Ventilation System
ON When EQing

Figure 5- 20 Ventilation System Setup

Installation, Operation and Maintenance
Charger Configuration
CLEAR
ENTER
CLEAR
ENTER
ENTER
34
Charger Configuration
Verify Ventilation
Connection
CLEAR
Verify Ventilation
Connection
CLEAR
Webasto Charging Systems, Inc.