4.12.9 Temperature Readout Selection
Allows the user to set the battery temperature display format to either degrees Fahrenheit or
Celsius.
From the "Temperature Readout Selection" screen, press <enter> to display the current format.
Press <enter> again to enable editing. Use the <up> and <down> arrows to select the desired
format for the temperature display and press <enter> to save your configuration. Press <clear>
to exit.
4.12.10
NOTE: This section is only applicable if a ventilation system has been installed and
connected to the charger.
The Ventilation System menus allow the user to set the ventilation system control parameters.
From this menu, the charger may be configured to turn the ventilation system off, to turn it on
only during Equalization, or to turn it on any time the vehicle is being charged.
From the "Ventilation System" screen Press <enter> and then Press <enter> again and the
status (ON or OFF) will flash. Press <up> or <down> to toggle between ON and OFF. Press
<enter> again to accept your selection. Press <clear> to exit.
CLEAR
12876-W-03-01
Temperature Readout
Selection
CLEAR
Display Temp in:
Fahrenheit
CLEAR
Display Temp in:
Celsius
Figure 4-22 Temperature Readout Selection Screens
Ventilation System
Ventilation System
Configuration
CLEAR
Ventilation System
OFF
ENTER
Ventilation System
ON When Charging
Ventilation System
ON When EQing
Figure 4-23 Ventilation System Setup
CLEAR
ENTER
CLEAR
ENTER
ENTER
ENTER
29
SVS100N Operation/Maintenance Manual
Charger Configuration
Charger Configuration
Verify Ventilation
Connection
CLEAR
Verify Ventilation
Connection
CLEAR
Webasto Charging Systems, Inc.