Auto Config Exit Mode; Configurable Parameters; Module - Deif SGC 420 User Manual

4. The display shows this screen:
PASSWORD
5. Enter the password:
• Use the Up and Down
• Select a number with the Start
6. You can now configure the parameter.
7. To leave the configuration menu, push and hold the Stop/Config
8. Until the configuration is saved, the display shows this screen:
3.4.1

Auto config exit mode

The controller automatically exits the configuration menu when there is no user interaction for a certain amount of time. You
can configure this time.
The controller saves all the configuration parameter changes before leaving the menu.
3.5

Configurable parameters

3.5.1

Module

General
Parameter
Profile name
Power On mode
Power On lamp test
Deep Sleep Mode
Load Histogram
Auto-Clear Warning
Alarm
User manual 4189341341B EN
buttons to change the number.
button.
Range
-
Manual
AUTO
Enable
Not enabled
Enable
Disable
Enable
Disable
Enable
Disable
button.
Default
Profile 1
-
Not enabled
Not enabled
Not enabled
Not enabled
Description
You can change the name of the profile.
The controller operates in this running mode
when you power on the controller.
If this parameter is enabled, the LEDs glow red
for 2 seconds after a power reset.
If this parameter is enabled, the controller goes
into deep sleep mode when the controller is not
in use for an adjustable time.
The load histogram shows the engine running
hours. The running hours are put into load
groups.
If this parameter is enabled, the controller
automatically clears an active alarm, when you
Page 22 of 89